Flintec MCS-08 Manual de usuario Pagina 41
- Pagina / 52
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
MCS-08 Technical Manual, Rev. 1.04 December 2012 Page 41 of 52
ST Status LED
State
Indication
Comment
Off
No power or not initialized
No power or profibus module is in initializing
Green
Initialized
Flashing Green
Initialized, diagnostic event(s) present
Diagnostic is active
Red
Exception error
There is an exception error
OP Operation Mode LED
State
Indication
Comment
Off
Not on-line / No power
Check power and cable
Green
On-line, data exchange
-
Flashing Green
On-line, clear
-
Flashing Red (2x)
PROFIBUS configuration error
Check GSD file configuration.
10.2. Electrical Connections
Profibus and RS-232C connections are shown in figure 10.2.
PROFIBUS Connector (DB9F)
Pin
Signal
Description
1
-
-
2
-
-
3
B Line
Positive RxD / TxD, RS-485 level
4
RTS
Request to send
5
GND Bus
Ground (isolated)
6
+5V Bus output
+5V termination power (isolated)
7
-
-
8
A Line
Negative RxD / TxD, RS-485 level
9
-
-
Housing
Cable shield
Ground
Figure 10.2 – MCS-08PB interface connections
RS-232C Serial Interface
Use
Setup via xFace
Baud rate
9600 bps
Length and parity
8 bit no parity
Start / Stop bits
1 start bit and 1stop bit
Profibus-DP Interface
Use
Interfacing with PC or PLC
Data format
Profibus
Baud rate
Automatically detected and supported baud rates are 9.6 kbps, 19.2 kbps, 45.45
kbps, 93.75 kbps, 187.5 kbps, 500 kbps, 1.5Mbps, 3 Mbps, 6 Mbps and 12
Mbps. No „baud rate‟ instance exists.
Warning: Connect the shield to the reference ground or shield pin of the power connector.
Warning: Disconnect xFace PC software for Profibus interfacing.
- Technical Manual 1
- RIGHTS AND LIABILITIES 3
- 1. SAFETY INSTRUCTIONS 4
- EG-Konformitätserklärung 5
- EC-Declaration of Conformity 5
- 3. INTRODUCTION 6
- 3.2. Specifications 7
- 3.3. Housing 9
- 3.4. Accessories 10
- 4. INSTALLATION 11
- 4.2. Electrical Connections 12
- 4.3. Commissioning 13
- 5. SETUP 14
- 5.3. N-Bus Addressing 15
- 5.4. Gateway Setup 16
- 5.5.1. Scale Parameters 17
- Auto Zero Tracking 18
- Save Tare at Power Off 18
- Mode selection 18
- Scale Build 19
- Calibration by Test Weights 19
- Zero Adjustment 19
- Span Adjustment 20
- Span Adjustment under Load 20
- 5.7. Digital I/O Test 21
- Not In Use 29
- – A/D CONVERTER MODULE 33
- 6.2. Electrical Connections 34
- 6.3. Setup and Calibration 34
- – DISPLAY MODULE 35
- – DIGITAL I/O MODULE 36
- – MODBUS RTU GATEWAY 37
- 9.2. Electrical Connections 38
- 9.3. N-Bus Addressing 38
- 9.4. Modbus RTU Setup 38
- – PROFIBUS GATEWAY 40
- 10.2. Electrical Connections 41
- 10.3. N-Bus Addressing 42
- 10.4. Profibus Setup 42
- – PROFINET GATEWAY 43
- 11.3. N-Bus Addressing 45
- 11.4. ProfiNet Setup 45
- – ETHERNET GATEWAY 46
- Ethernet Connector (RJ45) 47
- RS-232C Serial Interface 47
- Ethernet Interface 47
- 12.3. N-Bus Addressing 48
- 12.4. Ethernet Setup 48
- 13. ERROR TABLE 49
- 14. DIAGNOSTICS 50
- REQUENTLY ASKED QUESTIONS 51
Relacionado con productos y manuales para Hardware Flintec MCS-08
Hardware Flintec MCS-64 CANbus Manual de usuario
(62 paginas)
(62 paginas)
Hardware Flintec LDU 68.2 Manual de usuario
(28 paginas)
(28 paginas)
Hardware Flintec LDU 69.1 Manual de usuario
(28 paginas)
(28 paginas)
Hardware Flintec LDU 78.1 Manual de usuario
(36 paginas)
(36 paginas)
Hardware Flintec KAL-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KA-1 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec FAD-4 Manual de usuario
(26 paginas)
(26 paginas)
Hardware Flintec FDT-B Manual de usuario
(23 paginas)
(23 paginas)
Hardware Flintec KAK-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KA-6 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KEK-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KPK-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KP-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KPF-10 Manual de usuario
(8 paginas)
(8 paginas)
Hardware Flintec KAEX-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KEEX-4 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KPEX-10 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KPFD-8 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Flintec KPB-4 Manual de usuario
(4 paginas)
(4 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.070 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales